Firmware Download

Download the old version

Download Type Firmware
Model name IC-7800
Version Ver.2.20
Update May.19.2009
Major changes

Major points of the Ver.2.20 update.

  1. Adds the ability to send TX memory contents, while operating in either the RTTY mode, or the PSK31 mode, pushing one of the 4 keys on an external keypad. (More details of the external keypad are described on page 2-6 of IC-7800 instruction manual.)
  2. Adds the ability to send VOICE memory, in the SSB mode, or CW memory keyer contents, in the CW mode, by pushing one of the F1 – F4 keys on an external USB keyboard.
  3. Enables the operator to program custom band-edge frequencies. You can also hear a beep when tuning out of, or into the programmed Amateur band. The operator can now limit transmitting outside the programmed frequency band.
  4. The transmit capability on the 7MHz band has been extended from 7.0-7.1MHz to 7.0-7.2MHz. The RX frequency range has also been extended. (The modification applies to only Italian version.)
  • Please save the transceiver’s data contents to a CF card before starting the firmware update.
  • Never cut off power to the transceiver while updating the firmware.
  • Please read through Section 16 (UPDATING THE FIRMWARE) in the IC-7800 instruction manual, before downloading the new firmware.
  • Please also download Firmware update utility VER.1.0 ZIP(256KB) when updating the firmware using a LAN.
Note
File Size 3.84MB
File Type zip

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.

You need Adobe Acrobat Reader to view these PDF files. If you do not have this installed, please download the software by clicking on the icon at left.
Return to search page