Firmware Download

Download the old version

Download Type Firmware
Model name IC-7610
Version Version 1.04
Update Jan.09.2018
Major changes

Changes in this version

  • Eliminated an issue where noise was sometimes generated after a cold start.

To update the firmware

  • Thoroughly read Section 6. SD CARD/USB FLASH DRIVE of the BASIC MANUAL and the Section 13. UPDATING THE FIRMWARE of the ADVANCED MANUAL and follow the instructions displayed on the IC-7610.
  • The firmware will be updated to the following versions.
    Main CPU: 1.04
    Sub CPU: 1.01
    Front CPU: 1.00
    FPGA: 1.03
Note
File Size 7.57MB
File Type zip
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.