Firmware Download

Download the old version

Download Type	Firmware
Model name	VE-PG3
Version	Version 2.03
Update	Oct.21.2014
Major changes	Improvements are listed below. Bridge mode: • dPMR Mode 2 is supported • IP100H Bridge mode connection is supported • Serial control of the IC-F5060/F6060 series is supported • Serial communication between VE-PG3s is supported • The "Call Back RX to TX" function is added to the "Transceiver Control" setting Converter mode: • dPMR Mode 2 is supported • Serial communication between VE-PG3s is supported • The "Call Back RX to TX" function is added to the "Transceiver Control" setting • Squelch control from a transceiver is supported • The "Always Send during Talking" item is added to the "PTT Control Type from the Telephone" setting • A busy tone is added when a target of the IP100Hs or the IP100FSs is not connected to the system, or is out of range¹ ¹ To use this function, the following firmware are necessary • IP1000C version 1.33 or later • IP100H version 1.33 or later • IP100FS version 1.31 or later Notice: • If you update to version 2.03 from version 1.32 or earlier, you cannot downgrade to version 1.32 or earlier again. • You cannot use setting files made by version 2.03 or later using version 1.32 or earlier.
Note
File Size	3.72MB
File Type	zip

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.

I have read, fully understood and agree the above.

You need Adobe Acrobat Reader to view these PDF files. If you do not have this installed, please download the software by clicking on the icon at left.

Return to search page