Control software Download

Download the old version

Download Type Control software
Model name IC-R1500, IC-PCR1500, IC-R2500, IC-PCR2500
Version Ver.2.20
Update Jun.15.2011
Major changes

Major points of the Ver. 2.20 update.

  1. Both control software (Ver. 2.20) and USB device driver (Ver. 1.10), support Microsoft® Windows® 7(32/64bit).
  2. Took countermeasure for the issue of “no response from control software and PC seems to be hang up”, when you turn on both of “USB Audio” and “Confirmation Beep” of Control software at Windows® 7, and click any place in the virtual control panel in PC screen.
  3. Added manual selection of COM port and USB audio port.

    Note:
  • When update　the control software to Ver.2.20, the current PCR receiver firmware version should be Ver.2.10. If the firmware version in your receiver is not Ver.2.10, please first update the firmware to Ver.2.10.
  • Please read "Control software update information" thoroughly and make sure of what is required for the updating.
    Refer to the USB driver installation instructions written in “USB driver installation guide” and install the USB driver.
  • Never turn off the receiver power while the updating is being performed.
  • The software (Ver.2.20) is for Windows® XP, Windows Vista® and Windows® 7 only, if you require to the software and USB driver for Windows® 98SE/Me/2000, please use previous version’s Ver.2.11.
  • Save the setting data and memory data of your receiver before performing the software and firmware update.
Note
File Size 7.34MB
File Type zip

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.

You need Adobe Acrobat Reader to view these PDF files. If you do not have this installed, please download the software by clicking on the icon at left.
Return to search page