English | Español | Português
Icom America Home

IC-F9011 / F9021 Series

VHF P25 Conventional & Trunked Transceivers

specifications

Specifications

General
Frequency coverage

F9011T/S/B: 136–174 MHz
F9021T/S/B: 360-450, 400-470, 450-520 MHz

Number of channels Max. 512 channels/ 128 zones
Power supply requirement 7.2V DC nominal

Current drain (approx.)

Tx High (6W/5W) 2.2.A
Rx Max. Audio 800mA (backlight off)
Stand-by 300mA (backlight off)
Operating temperature range –30°C to +60°C; –22°F to +140°F
Antenna impedance 50Ω
Dimensions (W×H×D)

58.6×167×41.8mm;

2516×6916×12132in

Weight

533kg; 1.17 lb

Channel spacing 15/30 kHz (analog)
12.5 kHz (digital)
Transmitter
Output power 6W VHF, 5W UHF
Max. frequency deviation
Maximum pattern
±5.0/2.5 kHz (Wide/Narrow)
±2.85 kHz (Digital)
Frequency error ±1.0ppm
Spurious emissions 75/80 dB typ. (VHF/UHF)
Adjacent channel power 70/60dB min (wide/Narrow)
67dB min. (Digital)
FM hum and noise 45/40dB typ. (Wide/Narrow)
Audio harmonic distortion 2% typ. (40% deviation)
External microphone impedance 2.2kΩ (14-pin multiconnector)
Receiver
Sensitivity
Analog
Digital
0.25μV typ. (at 12dB SINAD)
0.30μV typ. (at 5% BER)
Squelch sensitivity 0.25μV typ. (at threshold)
Adjacent Ch. selectivity
Analog (TIA/EIA603B)
(TIA/EIA603)
Digital
75/48dB typ. (VHF, Wide/Narrow)
75/50dB typ. (UHF, Wide/Narrow)
80/70dB typ. (Wide/Narrow)
60dB typ.
Spurious  response 80dB min.
Intermodulation 75dB typ.
Audio output power
External audio (D-sub)
1.0W typ. at 10% distortion with a 4Ω load
Hum and noise ratio 50/45dB typ. (VHF, Wide/Narrow)
50/44dB typ. (UHF, Wide/Narrow)
External speaker connector 14-pin multi connector/8Ω

Applicable U.S. Military Specifications

Icom makes rugged products that have been tested to and passed the following MILSTD requirements and strict environmental standards.

Standard MIL 810 F
Method Proc
High Temp. 501.4 I, II
Low Temp. 502.4 I, II
Temp. Shock 503.4 I
Rain 506.4 I, III
Humidity 507.4
Dust 510.4 I
Immersion 512.4 I
Vibration 514.5 I
Shock 516.5 I, IV

Also meets equivalent MIL-STD-810-C, -D and -E.
Ingress protection standard:: Dust and water: IP57(Dust-protection and water resistant)

Measurements made in accordance with TIA-102 (Digital), TIA-603B (Wide/narrow). All stated specifications are subject to change without notice or obligation.

Supplied Accessories

  • Belt clip (MB-115)
  • Antenna
  • Battery pack, BP-254